Tack!JakePlisken skrev:Hej,
Nu svarar jag mig själv. Jag har hittat att default, så skickas en rapport automatiskt om ljusstyrkan förändras 100 lux. Kl 05:45 på morgonen så här års, så är det ju konstant mörkt, så därför skickas ingen rapport. Dock ska man kunna konfigurera så att den skickar rapporter med fast intervall
Klippt ur manualen:
Setting automatic report flags.
Parameter 101-103 [4 byte decimal] can be configured through your gateway in case
the default settings of your MultiSensor are not what you desire.
Decimal Lag
128 Light Sensor
64 Humidity Sensor
32 Temperature Sensor
1 Battery Sensor
The table above shows a decimal representation of all flags that can be set on
parameter 101-103 to report specific data.
Example use of the report table:
For example, if you want to report only the temperature and light sensor you would
add 32 + 64 and set the sum (96) to parameter 101, 102, or 103.
As another example, if you want to report only the light sensor and battery, you would
add 1 + 128, then set the sum (129) to parameter 101, 102, or 103.
And if you want to report all of the sensors, you would add the whole table together
and set the sum (225) to parameter 101, 102, or 103.
Setting an automatic report interval.
Parameter 111-113 [4 byte decimal] can be configured through your gateway in case
the default settings of your MultiSensor are not what you desire.
Parameter 111 will set the interval for Group 1 (parameter 101), parameter 112 will
set the interval for Group 2 (parameter 102), and parameter 113 will set the interval
for Group 3 (parameter 103).
As an example, you have set parameter 101 to 225 which will report all of the
sensors, and you want to report it every 1800 seconds. Set parameter 111 to 1800 to
accomplish this.
- Dock fattar jag inte hur jag ska kunna lägga till dessa parametrar. När jag via Veran klickar på pilen till höger om "Light Sensor" och på nästa sida klickar på pilen till höger om "Device Options", så är device options-sidan helt tom. Man har ingen möjlighet att lägga till parametrar här. Var lägger man i så fall till dem?
Mvh Jacob
Men kan du då inte göraJakePlisken skrev:Current level är det värde som är just nu i antal Lux.
Kod: Markera allt
tändning på morgonen kl 05:45 (förutsatt att "Current level < 50"